How to achieve quality assurance for your electronic designs
Clive Maxfield, EETimes
4/4/2011 11:22 AM EDT
It’s no secret that electronic designs are becoming ever more complex. I used to think things were hard enough back in 1980 when I was designing my first ASIC as a gate-level schematic using pencil and paper. Looking back, however, I realize life was a doddle and I had things easy – all I had to worry about was making sure the logic was functionally correct and would fit in the device (a gate array containing 2,000 equivalent gates) and that the timing was OK, which wasn’t particularly taxing since our system clock was sub-1MHz and we had lots of slack to play with.
We didn’t even think about things like leakage power and dynamic power consumption. Now, of course, we’re talking about designs containing millions upon millions of logic gates, including humungous blocks of third-party IP, more processor cores and hardware accelerators than you can swing a stick at, with millions of lines of software thrown into the mix.
So how do we ensure the quality of all aspects of an electronic design, including hardware (digital, analog, mixed-signal...) and software (boot code, test routines, firmware, drivers...) for anything from FPGAs and SoCs to full-blown embedded systems?
To read the full article, click here
Related Semiconductor IP
- CAN XL Verification IP
- Rad-Hard GPIO, ODIO & LVDS in SkyWater 90nm
- 1.22V/1uA Reference voltage and current source
- 1.2V SLVS Transceiver in UMC 110nm
- Neuromorphic Processor IP
Related White Papers
- Building a Total Quality Experience into Silicon IP - Delivering DesignWare Silicon IP into SoC Designs
- ipPROCESS: A Usage of an IP-core Development Process to Achieve Time-to-Market and Quality Assurance in a Multi Project Environment
- Quality Assurance for Embedded Systems
- Semiconductor Reliability and Quality Assurance--Failure Mode, Mechanism and Analysis (FMMEA)
Latest White Papers
- OmniSim: Simulating Hardware with C Speed and RTL Accuracy for High-Level Synthesis Designs
- Balancing Power and Performance With Task Dependencies in Multi-Core Systems
- LLM Inference with Codebook-based Q4X Quantization using the Llama.cpp Framework on RISC-V Vector CPUs
- PCIe 5.0: The universal high-speed interconnect for High Bandwidth and Low Latency Applications Design Challenges & Solutions
- Basilisk: A 34 mm2 End-to-End Open-Source 64-bit Linux-Capable RISC-V SoC in 130nm BiCMOS