Moore's Law did indeed stop at 28nm
September 21, 2016
As we have predicted two and a half years back, the industry is bifurcating, and just a few products pursue scaling to 7nm while the majority of designs stay on 28nm or older nodes.
Our march 2014 blog Moore’s Law has stopped at 28nm! has recently been re-confirmed. At the time we wrote: “From this point on we will still be able to double the amount of transistors in a single device but not at lower cost. And, for most applications, the cost will actually go up.” This reconfirmation can be found in the following IBS cost analysis table slide, presented at the early Sept FD-SOI event in Shanghai.
To read the full article, click here
Related Semiconductor IP
- UFS 5.0 Host Controller IP
- PDM Receiver/PDM-to-PCM Converter
- Voltage and Temperature Sensor with integrated ADC - GlobalFoundries® 22FDX®
- 8MHz / 40MHz Pierce Oscillator - X-FAB XT018-0.18µm
- UCIe RX Interface
Related Blogs
- Moore's Law and 28nm Yield
- Moore's Law Has Stopped at 28nm!
- 28nm Was Last Node of Moore's Law
- Moore’s Law and 40nm Yield
Latest Blogs
- Satellite communications are no longer as secure as assumed
- Why Hardware Monitoring Needs Infrastructure, Not Just Sensors
- Why Post-Quantum Cryptography Doesn’t Replace Classical Cryptography
- The Silent Guardian of AI Compute - PUFrt Unifies Hardware Security and Memory Repair to Build the Trust Foundation for AI Factories
- Heterogeneous NPU Data Movement Tax: Intel's Own Slides Tell the Story