Interface IP for VIS
Welcome to the ultimate Interface IP for VIS hub! Explore our vast directory of Interface IP for VIS
All offers in
Interface IP
for VIS
Filter
Compare
2
Interface IP
for VIS
from 1 vendors
(1
-
2)
-
USB 3.1 Cable Marker IP
- USB PD 3.1 compliant.
- Single chip solution – just two external capacitors.
- 4 pin package.
- Less than 1mm2 area in 180nm.
- PROM programmed through vendor message protocol.
- Based on Obsidian’s mature PD technology.
- Integrated PROM enables customized response to a wide range of vendor requirements.
- Active Ra pulls down only requires 10uA at 5V., but is <1K below 2V.
- Power <5mW. Enabled by CC data activity. I.e. very low duty cycle.
- Programming can be done after assembly into the cable. Fuse lock function.
- Supports low cost, 4 layer PCB assembly.
-
Complete USB Type-C Power Delivery IP
- Mixed signal Analog Front End Macros for 65n, 130n, 150nm, and 180n technologies.
- RTL code from AFE to I2C compatible register set.
- Stand alone C code for Protocol, Device Policy Manager, and System Policy Manager.
- IP demonstration & development board, with compliance reports.
- Full chip integration of USB Type-C, and associated software.
