Oscillator IP for UMC
Welcome to the ultimate
Oscillator IP
for
UMC
hub! Explore our vast directory of
Oscillator IP
for
UMC
All offers in
Oscillator IP
for
UMC
Filter
Compare
70
Oscillator IP
for UMC
from 9 vendors
(1
-
10)
-
Crystal Oscillators
- The crystal oscillator macros are available in a wide range of industry-standard quartz crystals and MEMS resonators operating in the fundamental mode in the 32 kHz to 80 MHz range.
- These oscillators, which are both power and area efficient, have a programmable transconductance to allow users to find the optimal balance between jitter and power consumption.
-
5MHz-35MHz Low Power Crystal Oscillator - TSMC 0.18µ
- 4MHz-35MHz Frequency range.
- No external bias or limit resistors required.
- Current optimization for best power at frequency.
- Amplitude control loop.
- The OSCI pad input can be used as a CMOS input for test.
- Uses single 1.8V supply.
- Enable/power down provision.
-
Free running oscillators
- Compact and low power
- No external components
- Baseline CMOS logic process masks only
- Excellent frequency precision over PVT after trimming
-
High Performance Fractional-N RF Frequency Synthesizer PLLs for 5G, WiFi, etc
- Fractional-N digital PLL architecture, using an LC-tank oscillator
-
High Performance Fractional-N RF Frequency Synthesizer PLL in UMC 40LP
- Fractional-N digital PLL architecture, using an LC-tank oscillator
- Ultra-low jitter and ultra-low phase noise
-
4-GHz Jitter-optimized low-power digital PLL
- - Jitter below 10-ps
- - Super small: 90 x 90 microns!
- - Very low power: 15-mW
- - Broad frequency range: 4-GHz
-
Minimum-area low-power clocking PLL (1st gen)
- - Super small: 80 x 80 microns!
- - Very low power: 12-mW
- - Broad frequency range: 2-GHz
- - Fast lock
-
Low power oscillator insensitive to variations of power supply voltage and temperature
- Oscillator block consists of a low-power current-voltage reference circuit, comparator (operational amplifier), voltage controlled oscillator (5-stage current starved ring oscillator, VCO), frequency divider and frequency-to-voltage converter (FVC).
-
High-Stable Oscillator - TSMC 40nm(CLN40ULP) / UMC 55nm(LP)
- High accuracy +/-2%, +/-3%, +/-5% at Tj = -40C to +125C.
- The frequency can be adjusted from 150MHz to 160MHz.
- Reference clock is not required.
-
Crystal oscillator 10-30Mhz with digital frequency adjustment ± 100ppm
- 10 to 30Mhz crystal
- Clock synchronization with 5bits frequency adjustment ( ±100ppm)
- Phase noise [contact us]dBc/Hz at 1kHz offset [contact us]dBc/Hz at 10kHz offset
- Clock input for bypass mode