Programming heterogeneous multiprocessors
By Steve Preissig, Texas Instruments , Courtesy of DSP DesignLine
Aug 23 2006 (22:25 PM)
You may find that your best time to market, cost, and performance will come from a heterogeneous processor architecture—that is, a processor that includes both general-purpose processor (GPP) and digital signal processor (DSP) cores. Combining two or more processors into your design allows you to draw on the strengths of both, increasing your overall efficiency. Such a design, however, introduces new challenges to the software designer. How will you partition the system for optimal loading levels between the processors? How will you perform scheduling on independent processors to ensure dependent activities are executed in order and with the lowest latency? And how can you optimize inter-processor communications so that the computational benefits of a heterogeneous design are not lost to data-transfer overhead?
In this article, we will examine how to program a heterogeneous processor architecture based on the proven method of the Remote Procedure Call (RPC). We will examine how this method addresses the concerns listed above. We also explain how the RPC introduces some pitfalls, and show how they may be avoided.
To read the full article, click here
Related Semiconductor IP
- DeWarp IP
- 6-bit, 12 GSPS Flash ADC - GlobalFoundries 22nm
- LunaNet AFS LDPC Encoder and Decoder IP Core
- ReRAM NVM in DB HiTek 130nm BCD
- UFS 5.0 Host Controller IP
Related Articles
- The Hitchhiker's Guide to Programming and Optimizing CXL-Based Heterogeneous Systems
- Embedded Systems: Programmable Logic -> Programming enters designer's core
- Tools For Reprogrammability -> Reuse forces embedded programming
- Network processors need a new programming methodology
Latest Articles
- VolTune: A Fine-Grained Runtime Voltage Control Architecture for FPGA Systems
- A Lightweight High-Throughput Collective-Capable NoC for Large-Scale ML Accelerators
- Quantifying Uncertainty in FMEDA Safety Metrics: An Error Propagation Approach for Enhanced ASIC Verification
- SoK: From Silicon to Netlist and Beyond Two Decades of Hardware Reverse Engineering Research
- An FPGA-Based SoC Architecture with a RISC-V Controller for Energy-Efficient Temporal-Coding Spiking Neural Networks