Latches and timing closure: a mixed bag
Ashish Goel & Ateet Mishra, Freescale Semiconductor
EETimes (8/2/2011 3:29 PM EDT)
Introduction
Digital blocks contain combinational and sequential circuits. Sequential circuits are the storage cells with outputs that reflect the past sequence of their input values, while output of the combinational circuits depends only on the present input. Latches and flip flops are the commonly used storage elements.
This paper is divided into 4 parts. First part of the paper will discuss the advantages and disadvantages of latches compare to Flip-Flop. Next part describes some unique properties of latches that make them useful in high-frequency design. Third part of the paper will talk about the timing analysis complexities for latch-based design and how to deal with this complexity during the course of design. Finally, the paper will discuss challenges with latch-based design to hierarchical timing closure and partitioning, and some solutions.
To read the full article, click here
Related Semiconductor IP
- HBM4 PHY IP
- Ultra-Low-Power LPDDR3/LPDDR2/DDR3L Combo Subsystem
- HBM4 Controller IP
- IPSEC AES-256-GCM (Standalone IPsec)
- Parameterizable compact BCH codec
Related Articles
- FPGA prototyping of complex SoCs: Partitioning and Timing Closure Challenges with Solutions
- Timing Closure on FPGAs
- Deriving design margins for successful timing closure
- Design Rule Violation fixing in timing closure
Latest Articles
- A 14ns-Latency 9Gb/s 0.44mm² 62pJ/b Short-Blocklength LDPC Decoder ASIC in 22FDX
- Pipeline Stage Resolved Timing Characterization of FPGA and ASIC Implementations of a RISC V Processor
- Lyra: A Hardware-Accelerated RISC-V Verification Framework with Generative Model-Based Processor Fuzzing
- Leveraging FPGAs for Homomorphic Matrix-Vector Multiplication in Oblivious Message Retrieval
- Extending and Accelerating Inner Product Masking with Fault Detection via Instruction Set Extension