ESD Protection IP for TSMC

Compare 43 ESD Protection IP for TSMC from 2 vendors (1 - 10)

1.0-3.3V GPIO With I2C Open Drain And 3.3V & 5V Analog Cells in 55nm
- 1.0V-3.3V | 3.3V IO operation
- Dual independent IO rails
- Output enable / disable (HiZ when disabled)
- Power-down control (HiZ upon VDD disable)
A 180nm Flip-Chip IO library with 1.2-1.8V GPIO, 1.8V & 5V analog/RF, 20-36V ultra-low leakage low-cap HV analog and OTP program cell
- GPIO:
- ANALOG
- OTP Programming Cell
- Physical Attributes
1.8V/3.3V Switchable GPIO With 5V I2C Open Drain & Analog in 16/12nm
- Multi-voltage 1.8V / 3.3V switchable operation
- 4 selectable drive strengths (25-235MHz @1.8V, 10pF)
- Full-speed output enable
- Independent power sequencing
A 28nm 1.8V-3.3V Fail-Safe General-Purpose IO & OSC
- Fail-Safe GPIO in TSMC 28nm process technology
- Physical features
- This library also features a 33MHz OSC (3.3V).
LVDS IO Pad Set
- Powered from 1.8V ±10% and 1.0V (±10%) to 1.1V (-10%/+5%) core power supplies
- Operates up to 1.2GHz (2.4Gbps)
- Input receive sensitivity of 75mV peak differential (without hysteresis)
- Common mode range from 0V to 2.4V (limited by Power Supply)
1.8V General Purpose I/O Pad Set
- Bidirectional GPIO Driver Features
- In full-drive mode, this driver can operate to frequencies in excess of 100MHz with 15pF external load and 125 MHz with 10pF load. Actual frequency limits are load and system dependent. A maximum of 200 MHz can be achieved under small capacitive loads.
I3C I/O Library
- Supported I3C operating modes:
- In open-drain modes, this cell requires a pull-up to a high voltage power supply (VDDP). The sizing of an external resistor or appropriate pull-up network is application dependent.
1.2V GPIO library designed for the SVID three-line interface.
- Open drain operation only
- Operating frequency – up to 25MHz
- Fault-tolerant to 1.32V at PAD (no current flow when DVDD = 0V)
- Output enable
1.2V GPIO
- ESD Protection
- Latch-up Immunity:
1.8V General Purpose Staggered I/O Pad Set
- Bidirectional GPIO Driver Features
- ? Multi-Voltage (1.2V, 1.5V, 1.8V)
- ? LVCMOS / LVTTL input with selectable hysteresis
- ? Programmable drive strength (rated 2mA to 12mA)