Managing energy consumption in wireless IoT devices
Jacob Beningo
embedded.com (March 31, 2018)
As the IoT develops and more edge devices are deployed in the field, undoubtedly a significant portion of those devices will be battery operated. Battery operated wireless edge nodes are convenient and cost effective because they require no access to electrical infrastructure and can be easily deployed. The potential problem with battery operated devices is that when developers are under the gun to get their devices built and out the door, battery life is one of the last things on their mind. There are several things that a developer can do throughout their development cycle to ensure that they will be able to properly manage their device’s energy consumption.
First, when a developer is designing their hardware, they need to break-up their hardware into subsystems and provide the ability to add a current shunt resistor to measure the current consumption for each subsystem.
To read the full article, click here
Related Semiconductor IP
- HBM4 PHY IP
- Ultra-Low-Power LPDDR3/LPDDR2/DDR3L Combo Subsystem
- MIPI D-PHY and FPD-Link (LVDS) Combinational Transmitter for TSMC 22nm ULP
- HBM4 Controller IP
- IPSEC AES-256-GCM (Standalone IPsec)
Related Articles
- Firmware Compression for Lower Energy and Faster Boot in IoT Devices
- Securing UART communication interface in embedded IoT devices
- MIPI in next generation of AI IoT devices at the edge
- Securing IoT Devices With ARM TrustZone
Latest Articles
- A 14ns-Latency 9Gb/s 0.44mm² 62pJ/b Short-Blocklength LDPC Decoder ASIC in 22FDX
- Pipeline Stage Resolved Timing Characterization of FPGA and ASIC Implementations of a RISC V Processor
- Lyra: A Hardware-Accelerated RISC-V Verification Framework with Generative Model-Based Processor Fuzzing
- Leveraging FPGAs for Homomorphic Matrix-Vector Multiplication in Oblivious Message Retrieval
- Extending and Accelerating Inner Product Masking with Fault Detection via Instruction Set Extension