High-Speed Board Layout Challenges in FPGA/SDI Sub-Systems
By Tsun-Kit Chin, National Semiconductor Corp.
pldesignline.com (November 18, 2009)
Introduction
Television and cinema have entered the digital age. Video pictures are used to transport at standard definition rate (270 Mb/s), upgraded to high definition rate (1.485 Gb/s), and are now migrating to 3 Gb/s. The migration to higher speeds enables higher resolution images for entertainment, but it also presents challenges to hardware engineers and physical layout designers. Many video systems are implemented with feature-rich FPGA and multi-rate SDI integrated circuits that support high performance professional video transport over long distances. FPGAs demand high density routing with fine trace width while high-speed analog SDI routing demands impedance matching and signal fidelity. This paper outlines the layout challenges facing hardware engineers and provides recommendations for dealing with these challenges.
To read the full article, click here
Related Semiconductor IP
- DeWarp IP
- 6-bit, 12 GSPS Flash ADC - GlobalFoundries 22nm
- LunaNet AFS LDPC Encoder and Decoder IP Core
- ReRAM NVM in DB HiTek 130nm BCD
- UFS 5.0 Host Controller IP
Related Articles
- Consumer IC Advances -> Set- top box SoC ready for high-speed demands
- IC Physical Design: Portable Layout and Simulation Technigues for ADSL Analog Devices
- Chip, board designers differ on preferences, concerns
- Layout compaction accelerates SoC design through hard IP reuse
Latest Articles
- VolTune: A Fine-Grained Runtime Voltage Control Architecture for FPGA Systems
- A Lightweight High-Throughput Collective-Capable NoC for Large-Scale ML Accelerators
- Quantifying Uncertainty in FMEDA Safety Metrics: An Error Propagation Approach for Enhanced ASIC Verification
- SoK: From Silicon to Netlist and Beyond Two Decades of Hardware Reverse Engineering Research
- An FPGA-Based SoC Architecture with a RISC-V Controller for Energy-Efficient Temporal-Coding Spiking Neural Networks