HYPERRAM Controller IP
Filter
Compare
6
IP
from 4 vendors
(1
-
6)
-
Winbond HyperRAM Controller
- The HyperRAM controller supports Winbond’s HyperBus based HyperRAM devices
- This controller enables smooth integration of Winbond’s HyperBus HyperRAM memory chips into various new-gen SoCs’.
-
xSPI NOR/NAND Flash & HyperRAM Controller
- Memory mapped access to the connected flash devices
- Continuous Burst transfer support
- Auto boot support
-
Simulation VIP for HyperRam
- Density
- From 64Mb to 128Mb
- Reset
- Hardware Reset via RESET# pin
-
AHB Octal SPI Controller with PSRAM and XIP Support
- The Octal SPI Memory Controller IP core is a serial peripheral interface (SPI) master which controls an external serial device, usually an industry-standard FLASH or PSRAM memory device.
- In Software Mode, an AHB Master may access the register interface of the Controller to implement a wide range of protocol variants and/or commands on the SPI bus.
-
xSPI - PSRAM Master
- The xSPI/PSRAM master IP is easy to use, simple to work with, quick to operate, and reliable under all conditions. It supports the xSPI JESD~251 standard from a standard AXI3 or AXI4 slave interface.
- It also supports APMemory Octal/QSPI RAM, HyperRAM, HyperFlash, and features backwards compatibility support for Octal SPI, QSPI, DSPI, and SPI interfaces.
-
xSPI PHY
- The xSPI PHY is designed to work with both the xSPI/PSRAM and the xSPI master host controller IPs. When coupled with the ACS xSPI PHY, the combined IPs are able to interact with SPI, Dual SPI, Quad SPI, Octal SPI, and xSPI devices at the full 200 MHz data rate.
- This includes both HyperRAM and HyperFlash protocols. Both single and dual data rate modes are supported. The xSPI Master controller IP supports flash devices, whereas the xSPI/PSRAM controller has been designed to support SRAM types of devices using the same interface.
