Boundary scan: Seven benefits
Chintan Panchal & Parth Rao (eInfochips)
EDN (May 08, 2014)
Boundary Scan: What Is It?
Boundary scan test techniques were first discussed in the late 1980s. At the time, experts believed that the growing complexity of chips would have a serious effect on an ICT system's ability to place a nail accurately on a test pad. In addition, the development of multi-layer boards compounded the problem of physical access for testing interconnects between devices on a PCB.
Many of the testing industry experts predicted that the “bed of nails” test system would disappear with the increasing complexity of chips. As a result, a group of concerned test engineers banded together to address this problem. The group was known as the Joint Test Action Group (JTAG). Their preferred solution was to access device pins by means of an internal serial shift register around the boundary of the device as shown below. In the boundary scan design, the chip’s IOs were supplemented with the boundary scan cell (a storage element). The collection of boundary scan cells on a board can be configured in various ways to achieve a parallel-in, parallel-out shift register that is used for testing and for on-board programming purposes.
To read the full article, click here
Related Semiconductor IP
- UCIe Chiplet PHY & Controller
- MIPI D-PHY1.2 CSI/DSI TX and RX
- Low-Power ISP
- eMMC/SD/SDIO Combo IP
- DP/eDP
Related White Papers
- Signal Integrity --> LVDS extends utility of 1149.1 boundary scan test
- Boundary scan and JTAG emulation combine for advanced structural test and diagnostics
- Experts mull 'seven deadly myths' of SoC design
- Reconfigurable scan lowers test costs
Latest White Papers
- Achieving Lower Power, Better Performance, And Optimized Wire Length In Advanced SoC Designs
- The pivotal role power management IP plays in chip design
- What tamper detection IP brings to SoC designs
- Analyzing Modern NVIDIA GPU cores
- RISC-V in 2025: Progress, Challenges,and What’s Next for Automotive & OpenHardware