USB 2.0 PHY IP, Silicon Proven in TSMC 55LP

Overview

In order to deliver great performance and use little power, the whole physical layer (PHY) IP solution for USB 2.0 was developed. The High-Speed USB 2.0 Transceiver, which can be used with hosts, devices, or OTG function controllers, is implemented by the USB2.0 IP. The USB2.0 PHY IP specification, which supports Full-Speed (12 Mbps) and Low-Speed (1.5 Mbps) data rates, comes after UTMI+level 3. High-speed data transport @ 480Mbps can be achieved by combining several mixed-signal circuits. The USB2.0 PHY IP also supports the enhanced USB Battery Charging standards, designed for use in consumer electronics and mobile devices.Numerous factories and nodes, including "TSMC 28HPC+, TSMC 40LP, TSMC 40LL, UMC 28HPC, UMC 40LP, UMC 55SP, UMC 55EF, SMIC 14SF+, SMIC 40LL, SMIC 55LL," implement the USB 2.0 PHY IP standard. Performance and data throughput were unaffected by the tiny chip size and low power consumption of the USB2.0 PHY IP transceiver. The USB2.0 PHY IP offers a complete on-chip physical transceiver solution with Electrostatic Discharge (ESD) protection, a clock generating block provided by an internal PLL, and a resistor termination calibration circuit in order to completely enable host and device functionality.

Key Features

Compliant with USB2.0 and USB1.1 specification
Compliant with UTMI Specification Version level 3.
Supports HS(480Mbps)/FS(12Mbps) /LS(1.5Mbps) modes
All required terminations, including 1.5Kohm pullup on DP and DM, and 15Kohm pull-down on DP and DM are internal to chip
16-bit, 30MHz or 8-bit, 60MHz parallel interface for HS/FS
Serializing for transmitting data stream and Deserializing for receiving data stream
USB Data Recovery and Clock Recovery on receiving
Integrated Bit Stuffing and NRZI encoding for Transmit
Integrated Bit Un-Stuffing and NRZI decoding for Receive
SYNC and EOP generation on transmit packets and detection on receive packets
Internal reference resistor that replaces the external reference resistor
Built in self test for production testing
Supports USB suspend state and remote wakeup
Supports detection of USB reset, suspend and resume signaling
Supports high speed identification and detection as defined by USB 2.0 Specification
Support high speed host disconnection detection
Silicon Proven in TSMC 28nm, TSMC 40nm, UMC 28nm, UMC 40nm, UMC 55nm, SMIC 14nm, SMIC 40nm, SMIC 55nm
Silicon Proven in TSMC 55LP.

Block Diagram

Deliverables

Application Note / User Manual
Behavior model, and protected RTL codes
Protected Post layout netlist and Standard
Delay Format (SDF)
Frame view (LEF)
Metal GDS (GDSII)
Test patterns and Test Documentation

Technical Specifications

Maturity

In Production

Availability

Immediately

Request Info