IP Catalog > SD Card UHS-II PHY

SD Card UHS-II PHY IP

Filter
Filter

Login required.

Sign in

Search (6)
Compare 6 IP from 4 vendors (1 - 6)
  • Simulation VIP for SD CARD and SDIO
    • SD Card device standard
    • Speed Range A and B
    • Default Speed Range A and faster Range B support
    • PHY-LINK I/F
  • SD4.0 / UHS-II Host Controller & PHY
    • + Support Standard Capacity (SDSC), High Capacity (SDHC) and Extended Capacity (SDXC) cards
    • + 1 and 4-bit parallel legacy SD interface, and serial UHS-II interface
    • + All bus interface modes: legacy SD (DS, HS, SDR12, SDR25, SDR50, SDR104, DDR50) and UHS-II (FD156, HD312)
    • + Data transfer rate up to 104 Mbps with 4 parallel SD data lines
  • Block Diagram -- SD 4.1 SDIO 4.1 Host Controller IP
  • SD 4.0 Device Controller
    • Compliant with SD Specification 4.0
    • Transfers up to 312 MB/s (UHS156, 52MHz) and supports Half duplex(312 MB/s) and Full duplex (156 MB/s) in SD4.0 mode
    • Low voltage and low power consumption with enhanced power management using new power Control mode by allowing LPS (Low power states like – EIDL and DORMANT)
    • High-performance UHS-II PHY or UHS-I Host connection
  • eMMC 5.1 Host Controller
    • Compliant with eMMC Specification Version 5.0
    • Supports one of the following System/Host Interfaces: AHB, AXI or OCP
    Block Diagram -- eMMC 5.1 Host Controller
  • SDIO UHS II Verification IP
    • Supports SD specification UHS-II Adddendum version 2.00 compliant.
    • Supports Part E1 SDIO specification version 4.10.
    • Supports SD specification physical layer version 4.0/4.20/5.0/5.10/6.0/6.10/7.0/7.10/8.0(Draft).
    • Supports bi-directional receiver/transmitter (2ch) supporting both Full Duplex and Half Duplex modes.
    Block Diagram -- SDIO UHS II Verification IP
×
Semiconductor IP