Oscillator IP
Welcome to the ultimate Oscillator IP hub! Explore our vast directory of Oscillator IP
All offers in
Oscillator IP
Filter
Compare
318
Oscillator IP
from 37 vendors
(1
-
10)
-
Clock Attack Monitor
- The agileCAM is a Ring Oscillator (RO) based clock attack monitor designed to detect clock attacks due to violation of the set-up time requirements of critical circuits.
- agileCAM can detect attacks based on changes in clock frequency, clock hold and clock glitch errors.
- Additionally, it provides a relative frequency measurement of the monitored clock with programmable alarm thresholds.
-
32KHz Low Power Oscillator
- 850nW typical power @32KHz.
- Available frequencies 10KHz – 100KHz.
- No external components.
- 60ppm/°C temperature sensitivity.
- 0.3%/100mV vdd sensitivity.
- Base cell area 0.005mm2.
-
Integrated Oscillator - TSMC 180n
- The OT3912t is an integrated oscillator for TSMC 180n processes.
- No external components are required. After a simple trim process a frequency stability of better than 1% is achieved over voltage and temperature ranges.
-
5MHz-35MHz Low Power Crystal Oscillator - TSMC 0.18µ
- 4MHz-35MHz Frequency range.
- No external bias or limit resistors required.
- Current optimization for best power at frequency.
- Amplitude control loop.
- The OSCI pad input can be used as a CMOS input for test.
- Uses single 1.8V supply.
- Enable/power down provision.
-
5MHz-35MHz Crystal Oscillator - Austriamicrosystems 0.18µ
- 5MHz-35MHz Frequency range.
- No external bias or limit resistors required.
- Current optimization for best power at frequency.
- Duty cycle control loop.
- Amplitude control loop.
- The OSCI pad input can be used as a CMOS input for test.
-
Xtal Oscillator on TSMC CLN7FF
- Crystal Oscillator pad macro that supports industry standard crystals
- Uses standard CMOS transistors
- Crystal Oscillation Mode: Fundamental
- Power down option for IDDQ testing
-
Crystal-less Low Power Oscillator on TSMC CLN12FFC
- Crystal-less oscillator
- Uses standard CMOS transistors
- Accuracy within +/-35% untrimmed, +/-8% post-trim
- Under 50uA active power
-
Crystal Oscillator on TSMC CLN22ULL
- Crystal Oscillator pad macro that supports an industry standard crystals
- Uses standard CMOS transistors
- Crystal Oscillation Mode: Fundamental
- Power down option for IDDQ testing
-
20-40MHz Crystal Oscillator on TSMC CLN16FFC
- Crystal Oscillator pad macro that supports industry standard crystals in the 20-40MHz range
- Uses standard CMOS transistors
- Crystal Oscillation Mode: Fundamental
- Power down option for IDDQ testing
-
18-40MHz Crystal Oscillator on TSMC CLN6FF
- Crystal Oscillator pad macro that supports many industry standard crystals in the 18-40MHz range (e.g. 24MHz, 25MHz, 38.4MHz)
- Uses standard CMOS transistors
- Crystal Oscillation Mode: Fundamental
- Power down option for IDDQ testing