Design cost reduction
Designing ESD protection can be very costly: frequently many test structures are required, analysis needs to be done, IP positions need to be checked and respected…. Sofics has a wide range of solutions, for a wide range of applications, silicon proven in a wide range of processes. As an IP provider, we can distribute the ESD design cost over many different customers, lowering the cost for everyone.
Mask cost reduction
Nowhere the task of selecting the optimal, minimal mask set is more challenging than in BCD processes. Often a large variety of options are available. So far, Sofics always succeeded in creating protection using only the masks available for the functional elements of the IC.
Manufacturing cost reduction
In one example, a customer had a working product (an LCD driver), but the ESD protection consumed too much area. Sofics optimized the diode size and layout, reduced the I/O bus scheme and area, designed a new Sofics power clamp, and worked out a calculation sheet to determine optimum power clamp placement. This resulted in a 25% I/O size reduction, and an overall die area reduction of more than 12%, significantly cutting the product’s manufacturing cost. Since the Sofics engagement the customer has been able to make consistently smaller I/O’s and power cells, and has reduced the power clamp repetition rate. These enhancements lead to smaller and hence cheaper product dies. The customer has been rewarded with significantly increased competitiveness and a bigger market share.
Speed up time-to-market
Designing ESD protection can be very time consuming: often at least one silicon run is required, often setting back the IC design for a couple of months. Sofics has a wide range of solutions, for a wide range of applications, silicon proven in a wide range of processes, readily available at your fingertips.
Risk reduction
Typical ICs designed in high voltage or BCD processes end up in harsh to very harsh environments, such as automotive or industrial applications. Robustness requirements reach far beyond merely ESD specifications. Sofics’ approach with PowerQubic is to anticipate as much as possible the interaction of specifications and protection structures against the myriad of electrical hazards – optimizing for overall robustness..
Proven portability
BCD processes are all very different, and portability for one process or process generation to the next can trigger the need for a series of test chips in order to investigate process properties during various disturbances. Sofics has developed work-arounds enabling ESD protection for high voltage pins, often without the need for a test chip. In one example, a product IC was protected up to 4kV HBM and 200V MM in an untested 0.18um BCD process. The holding voltage of the protection was designed and delivered at 28V, well above the required 24V.