Linear Temperature Sensor

Overview

The TS_SN_TEMP_X8 is a temperature sensor generating an output voltage on VOUT, linearly increasing with junction temperature and trimmable to 2V at 60°C. It operates with a single supply voltage, VDDA4 (4V typical from the additional IP TS_VR_4V00_X8) and is meant for on-chip internal operation. Its inputs or outputs that need access to bond pads will require the insertion of ESD protected buffers.

The DC load current through VOUT must be kept at 0A. The possible load may be either capacitive or the input resistor of an inverting integrator.

The minimum continuous operation lifetime spans 100000 hours.

Operating conditions

Parameters Values
Junction temperature range 20ºC to +80ºC
Supply voltages VDDA4: 3.9V to 4.1V (supplied by the additional IP TS_VR_4V00_X8)
EN, TRIM<3:0> logic-high voltage level VDDA4

Specification

Parameters Values
Output voltage at TJ=60°C
EN = H, TRIM<3:0> = LHHH, HLLL or HLLH
Minimum 1.995V, typical 2.000V, maximum 2.005V
VOUT temperature coefficient
EN = H, TRIM<3:0> = HLLL
Typical +6.2mV/°C
Total output noise level over 1Hz to 10MHz
EN = H, TRIM<3:0> = HLLL
Maximum 0.3mVRMS
Thermal response 3dB cut-off frequency
EN = H, TRIM<3:0> = HLLL
Minimum 100Hz
Start-up time
Unloaded VOUT, EN toggling from L to H, TRIM<3:0> = HLLL
Maximum 10ms
Operating power consumption
Enable EN high (H), TRIM<3:0> = HLLL
200µW max
Powerdown-mode current consumption
Enable EN low (L)
100nA max
Area 0.117mm²

 
Vd0_AC and R0_AC must be interconnected. They are provided for temperature-response AC analysis simulations only.

Block Diagram

Linear Temperature Sensor Block Diagram

Technical Specifications

Short description
Linear Temperature Sensor
Vendor
Vendor Name
Foundry, Node
XFAB XT018 - 0.18µm HV SOI CMOS
Maturity
silicon proven
×
Semiconductor IP