ARM Cortex-M0+ IP
Filter
Compare
8
IP
from 4 vendors
(1
-
8)
-
Arm Cortex-M0+
- Memory protection unit - Software reliability improves when each module is allowed access only to specific areas of memory required for it to operate. This protection prevents unexpected access that may overwrite critical data.
- Binary upward compatible with all other Cortex-M processors - The Cortex-M0+ has mainly 16bit Thumb-2 instructions and few 32bit ones. These instructions are also present on all the other Cortex-M processors. Hence all code written for the Cortex-M0+ will run as is on the other processors.
- Built-in low-power features - Sleep, deep sleep and state retention are three low power modes available to the user.
- Optional Debug Access Port and Serial Wire Debug - For devices where every pin counts the serial wire debug port uses only two pins.
-
Small, Low Power, Energy Efficient 32-bit Microcontroller Processor
- Exceptional code density - on average, the mix between 16-bit and 32-bit instructions yields a better code density when compared to 8-bit and 16-bit architectures. This has significant advantages in terms of reduced memory requirements and maximizing the usage of precious on-chip Flash memory.
- Binary upward compatible with all other Cortex-M processors - the Cortex-M0 has mainly 16-bit Thumb-2 instructions and few 32-bit ones. These instructions are also present on all the other Cortex-M processors. Hence all code written for the Cortex-M0 will run as is on the other processors.
- Built-in low-power features - sleep, deep sleep and state retention are three low power modes available to the user
- Optional Debug Access Port and Serial Wire Debug - for devices where every pin counts the serial wire debug port uses only two pins
-
ComputeRAM
- Available as a 18 kB macro in GlobalFoundries 22FDX process; - Memory Compiler and FinFET variants under development
- Low power sleep mode with data retention
- Built using proven foundry SRAM bit cells, fully CMOS, strictly obeys foundry DFM/DRC rules
- Bit-accurate computation
-
AHB Subsystem
- Subsystem for microprocessors with 32-bit AMBA® 3.0 AHB-Lite or AHB Interfaces, such as: BA2x, ARM Cortex-M0/M1M3/M4, and Several RISC-V processors
- AHB-SBS-BASE integrates: AHB Multi-Layer Interconnect, xSPI Controller, SRAM Controller, and APB Subsystem (APB-SBS) (I2C, SPI, UART. GPIO, RTC. Timer, WDT, and PIC)
- AHB-SBS-EXT adds: Multichannel DMA, SPI-to-AHB bridge, and External parallel flash or SRAM controller
- Highly configurable and customizable
-
APB Subsystem
- AMBA® APB Bridge and Peripherals for rapid integration with processors like: BA2x, ARM Cortex-M0/M1M3/M4, and several RISC-V processors
- AHB or AXI to APB Bridge
- 2C Master/Slave
- Single, Dual, Quad and Octal SPI Master/Slave
-
AHB Performance Subsystem - ARM M0
- Supports Cortex-M0 (or equivalent) processor
- AMBA® 2.0 (AHB)
- AHB Multi-matrix bus infrastructure
- External Nor Flash controller
-
AHB Low Power Subsystem - ARM M0
- Supports Cortex-M0 (or equivalent) processor.
- Power Management Unit
- AMBA® 3.0 (AHBLite)