DDR3 IP

Compare 47 DDR3 IP from 13 vendors (1 - 10)

DDR3 Controller
- Maximizes bus efficiency via look-ahead command processing, bank management, auto-precharge and additive latency support
- Latency minimized via parameterized pipelining
- Achieves high clock rates with minimal routing constraints
- Supports full-rate and half-rate clock operation
- Multi-mode controller support
DDR PHY
- DDR5/4/3 training with write-leveling and data-eye training
- Optional clock gating available for low-power control
- Internal and external datapath loop-back modes
- I/O pads with impedance calibration logic and data retention capability
- Programmable per-bit (PVT compensated) deskew on read and write datapaths
- RX and TX equalization for heavily loaded systems
DDR2 & DDR3 Fault Tolerant Memory Controller
- Configurable to have multiple AHB ports with concurrent accesses to different memory banks
- 96-, 64- or 32-bits interface towards SDRAM
DDR3 Monitor Verification IP
- Supports DDR3 memory devices from all leading vendors
- Quickly validates the implementation of the DDR3 standard
- Constantly monitors DDR3 behavior during simulation
- Checks for following
GDDR3 Synthesizable Transactor
- Supports 100% of GDDR3 protocol standard
- Supports all the GDDR3 commands as per the specs
- Supports all types of timing and protocol violation detection
- Supports all mode registers programming
DDR3 DFI Synthesizable Transactor
- Compliant with DFI version 2.0 or higher Specifications.
- DFI-DDR3 Applies to :
- DDR3 protocol standard JESD79-3F Specification
- Supports all the Interface Groups.
DDR3L Synthesizable Transactor
- Supports 100% of DDR3L protocol standard 8Gb DDR3L.pdf
- Supports all the DDR3L commands as per the specs
- Supports up to 8 GB device density
- Supports 8 internal banks
DDR3 3DS Synthesizable Transactor
- Supports 100% of DDR3 3DS protocol standard JESD79-3-3
- Supports all the DDR3 3DS commands as per the specs
- Supports up to 64GB device density
- Supports 64 internal banks
DDR3 Synthesizable Transactor
- Supports 100% of DDR3 protocol standard JESD79-3F
- Supports all the DDR3 commands as per the specs
- Supports up to 8 GB device density:
- Supports following devices:
DDR3 DFI Verification IP
- Compliant with DFI version 2.0 or higher Specifications.
- DFI-DDR3 Applies to :
- DDR3 protocol standard JESD79-3F Specification
- Supports all the Interface Groups.