VolTune: A Fine-Grained Runtime Voltage Control Architecture for FPGA Systems
By Akram Ben Ahmed, Takahiro Hirofuchi, Takaaki Fukai
Intelligent Platforms Research Institute, National Institute of Advanced Industrial Sciences and Technology, Tokyo, Japan
Abstract
The rapid emergence of edge computing platforms and large-scale data centers has made power efficiency a primary design constraint, particularly for data-intensive and AI-driven workloads. Field-programmable gate arrays (FPGAs) are increasingly adopted due to their flexibility and potential for energy-efficient acceleration. However, FPGA supply voltages are typically fixed at design time using conservative margins, limiting the ability to adapt power consumption to runtime conditions.
This paper presents VolTune, an open-source runtime voltage control architecture that enables runtime tuning of FPGA supply voltages through FPGA-integrated control logic that abstracts low-level PMBus operations. VolTune provides both hardware-based and software-based control paths, allowing designers to balance deterministic low-latency operation against programmability.
In the presented prototype, the hardware-based control path achieves a measured end-to-end voltage transition latency of 2.3 ms, while the controller adds under 2% static power overhead and under 2% FPGA resource overhead. As a representative case study, VolTune is evaluated on the GTX transceiver supply rail of a Kintex-7 platform. The results show that runtime voltage tuning exposes a bounded operating region with clear trade-offs between energy efficiency and reliability, and achieves up to approximately 29.3% rail-power reduction at 10.0 Gbps when allowing BER up to 10e-6. These results show that FPGA-integrated runtime voltage control can provide practical energy savings with low integration overhead.
To read the full article, click here
Related Semiconductor IP
- Chiplet Die-to-Die Interconnect IP Solution
- High speed MACsec Engine 100G/200G/400G/800G/1.6T
- Temperature/Voltage sensors
- AMBA Bus Host to eSPI Controller/Target
- AMBA Bus Host to eSPI Controller
Related Articles
- SynapticCore-X: A Modular Neural Processing Architecture for Low-Cost FPGA Acceleration
- A Direct Memory Access Controller (DMAC) for Irregular Data Transfers on RISC-V Linux Systems
- An FPGA-Based SoC Architecture with a RISC-V Controller for Energy-Efficient Temporal-Coding Spiking Neural Networks
- A Persistent-State Dataflow Accelerator for Memory-Bound Linear Attention Decode on FPGA
Latest Articles
- ZK-Flex: A Flexible and Scalable Framework for Accelerating Zero-Knowledge Proofs
- ITP-STDP: An Intrinsic-Timing Power-of-Two Learning Engine for On-Chip SNN Training
- OpenEye: A Scalable Open-Source Hardware Accelerator for DNNs
- CHIMERA: A Flexible and Scalable 3.1 TOPS/W AI-MCU with Transformer Accelerator and 563 Gb/s Shared-L2 Memory Subsystem with QoS Guarantees
- CXL-ClusterSim: Modeling CXL-based Disaggregated Memory Cluster for Pooling and Sharing using gem5 and SST