Designing with core-based high-density FPGAs
Robert S. Grimes, President, RSG Associates
EETimes (7/27/2011 9:36 PM EDT)
One engineer's adventures designing with microprocessor-based FPGAs.
Modern field programmable gate arrays (FPGAs) are great for a wide range of high-speed, complex signal processing but can be difficult to interface to external systems. Microprocessors are great for interfacing to other systems, especially when equipped with Ethernet for communications, but don't offer the same levels of performance.
Until recently, designers either had to work around the weak spots of the chosen device or combine the two devices; the latter approach presents new difficulties when the data rate between the signal processing and general processor is significant. Enter FPGA devices with built-in microprocessors, combining modern 32-bit microcontrollers and Ethernet media access controllers (MACs) with FPGA resources.
This article presents my experience with designing a nontrivial multiprocessor system, using three networked Xilinx Virtex-4FX-based controllers.
To read the full article, click here
Related Semiconductor IP
- nQrux® Root of Trust IP
- AXI to UCIe Bridge IP
- UCIe 2.x Controller IP
- SWI3S (SoundWire I3S Interface) Peripheral Controller Core IP
- OpenTitan-based RISC-V Secure Element
Related Articles
- How to test the interconnections between FPGAs on a high-density FPGA-based board
- Opto-electronics -> High-density fiber-optic modules eye next-gen switching architecture
- Static and dynamic modeling for high-density memories
- How to achieve faster compile times in high-density FPGAs
Latest Articles
- A Secure dToF LiDAR SoC with Dual-Domain Fingerprinting and Event-Driven AFE Circuit Achieving Sensor-Level Attack Resilience
- ZTA-Q: an Open-source RISC-V Platform for Accurate Quantized CNN Inference
- Automated Pre-Silicon Verification of High-Speed DDR5 and LPDDR5/6 Memory Controllers: Closed-Loop Timing, Mode Register, and PHY Synchronization in UVM
- U-Sonic: An Open-Source 8-Channel Ultrasound Transmit IP in a 130 nm RISC-V SoC
- S-ALSA: Co-Design of Adiabatic Logic-based Sensing and Balanced Bit-Cells for Secure and Energy-Efficient MRAM