How to test the interconnections between FPGAs on a high-density FPGA-based board
By Rajendra C Turakani and Ritesh Ramesh Parekh, Ittiam Systems.
Apr 11 2007 (14:17 PM), Programmable Logic DesignLine
Abstract
High-density FPGA-based boards are widely being used for logic development and verification before taping out the actual IC. On a high-density FPGA-based board where multiple FPGAs are interconnected with hundreds of signals, checking and validating the interconnections between the FPGAs becomes a very challenging task. This article describes how challenging the problem is and also suggests a simple, effective, and generic solution to check the signal connectivity between the FPGAs. The method also helps the designer to identify and locate faults, if any, on the board which otherwise would have been a very cumbersome task. This article also proposes a method to efficiently generate the test code, most of which could be automated.
To read the full article, click here
Related Semiconductor IP
- Zigbee Transceiver PHY
- Data Flow Architecture IP
- AMBA SPI Controller MRAM Controller
- Ethernet MAC
- Protocol Bridges
Related Articles
- Redefining Speed: How FPGAs are shaping the future of high-frequency trading
- What! How big did you say that FPGA is? (Team-design for FPGAs)
- Prototyping Mesh-of-Tree NOC Based MPSOC on Mesh-of-Tree FPGA Devices
- How FPGA technology is evolving to meet new mid-range system requirements
Latest Articles
- A Low-Latency ASIC Architecture for Real-Time Line Segment Detection
- BitFair: A 12nm Bit-Serial CNN Accelerator with Learnable Early Termination and Adaptive Bit Ordering for Ultra-Low-Power XR Vision
- A Flexible Sparsity-Aware FPGA Accelerator with Column-Wise Compression for Efficient CNN Inference
- Reducing Instruction-Fetch Energy in RISC-V for Embedded AI Processing via Dynamic and Static Loop Caching
- SPARC: Automated Root-Cause Analysis of Pre-Silicon Power Side-Channel Leakage in the Processor Design Flow