DC-DC Converter IP

Compare 90 DC-DC Converter IP from 15 vendors (1 - 10)

Power and Clock Generation IP - GLOBALFOUNDRIES® 22FDX®
- Tightly integrated power management platform with a soft-IP wrapper around Analog / Mixed-Signal hard macros which generate all supply voltages and clock signals needed to run highly efficient SoCs in GlobalFoundries® 22FDX®.
- Running from only one supply voltage and reference clock, the IP generates its own internal supplies and references, and those needed to run the Racyics® ABX® Generator.
Custom Regulated High Capacity Charge Pump
- On-Chip Supply Rail Extension
- Extends the headroom and performance range of other on-chip blocks and components
Coin Battery Boost
- Input Voltage Range: 0.9V to 1.8V
- (single alkaline or Ni-MH battery)
- 10 mA maximum output
- 18 uA quiescent current with no load
3.3V to 1.0V, 3.0A Step-down DC-DC converter
- Supply voltage: 3.3V analog and 1.0V digital
- Adjustable output voltage with trimming: 0.8V÷1.15V (1.0V typical)
- Maximum output current up to 3A
3.3V to 1.8V, 0.7A Step-down DC-DC converter
- Supply voltage: 3.3V analog and 1.0V digital
- Adjustable output voltage with trimming: 1.75V÷2.05V (1.8V typical)
- Output current 0.7A
- Soft start mode
2.0-3.6V to 1.0-1.4V step down DC/DC converter
- UMC 55nm eFlash CMOS technology
- Input Voltage Range: +2.0V to +3.6V
- Current limit detector
Ultra low power DCDC
- PWM mode and PSM mode control
- 2A maximum output current
- Dynamic output voltage scaling
- Spread-spectrum frequency modulation
3.3 - 4.2V to 0 - 200V step-up DC/DC converter
- XFAB XT018
- Input Voltage Range: 3.3V to 4.2V
- Output Voltage: 0 to 200V
3.3 - 4.2V to 0 - minus 100V step-down DC/DC converter
- XFAB XT018
- Input Voltage Range: 3.3V to 4.2V
- Output Voltage: 0 to minus 100V
20mA, 5V Boost Converter - Adjustable output voltage - SilTerra 0.18um
- This IP is an inductorless DC/DC converter (charge pump) that provides a stable and configurable output voltage VOC (from 4.8V to 5.5V) for loads up to 20mA.
- It is designed to work from 3MHz clock circuit and features limitation of in-rush current and power saving mode.