Five steps to FlexRay
Bernd Elend, NXP Semiconductors
Jan 25, 2007 (1:36 PM), commsdesign.com
FlexRay comes onto the road with single-channel high-speed power-train, driver-assistance, and comfort automotive electronics applications. On the new BMW X5, FlexRay is used in suspension control, allowing for a gentle learning phase with low risk for engineers and developers before applying the fault-tolerant, deterministic protocol to safety relevant driving functions using two communication channels and bus guardian supervision.
In developing FlexRay applications, there are five basic steps that design engineers can apply leading to a robust network topology.
To read the full article, click here
Related Semiconductor IP
- TSMC 4nm 3V3 GPIO
- 1 Kbyte EEPROM IP
- 3.6 Kbit EEPROM IP
- AMBA 5 AHB Bus TFT LCD / OLED Display Controller
- AMBA AXI5 / ACE5-Lite TFT LCD / OLED Display Controller
Related Articles
- Five Vital Steps to a Robust Testbench with DesignWare Verification IP and Reference Verification Methodology (RVM)
- Five steps to reliable, low-cost, bug-free software with static code analysis
- 5 Steps to Confront the Talent Shortage With IP-Centric Design
- The five facets of SoC design complexity
Latest Articles
- A Flexible Sparsity-Aware FPGA Accelerator with Column-Wise Compression for Efficient CNN Inference
- Reducing Instruction-Fetch Energy in RISC-V for Embedded AI Processing via Dynamic and Static Loop Caching
- SPARC: Automated Root-Cause Analysis of Pre-Silicon Power Side-Channel Leakage in the Processor Design Flow
- A Heterogeneous Neural Network Accelerator for End-to-End Multitask RF Signal Recognition
- Hardware-Software Co-Design for Float16 On-Device Training on RISC-V Single-Core