Designing for safety and security in a connected system
Dan Smith and Andrew Girson, Barr Group
embedded.com (September 06, 2017)
Good embedded software has always been designed for both safety and security. However, connectivity has introduced intolerable levels of security vulnerability in safety-critical applications such as medical, autonomous vehicles, and Internet of Things (IoT) devices.
The tight coupling of safety and security, combined with heightened threat levels, requires developers to fully understand the difference between safety and security; also, to apply industry best practices to ensure that both are designed into a product, right from the start (Figure 1).
To read the full article, click here
Related Semiconductor IP
- Zigbee Transceiver PHY
- Data Flow Architecture IP
- AMBA SPI Controller MRAM Controller
- Ethernet MAC
- Protocol Bridges
Related Articles
- How a Standardized Approach Can Accelerate Development of Safety and Security in Automotive Imaging Systems
- A 0.32 mm² 100 Mb/s 223 mW ASIC in 22FDX for Joint Jammer Mitigation, Channel Estimation, and SIMO Data Detection
- Designing AI enabled System with SOTIF (Safety Of The Intended Functionality)
- New Realities Demand a New Approach to System Verification and Validation
Latest Articles
- A Low-Latency ASIC Architecture for Real-Time Line Segment Detection
- BitFair: A 12nm Bit-Serial CNN Accelerator with Learnable Early Termination and Adaptive Bit Ordering for Ultra-Low-Power XR Vision
- A Flexible Sparsity-Aware FPGA Accelerator with Column-Wise Compression for Efficient CNN Inference
- Reducing Instruction-Fetch Energy in RISC-V for Embedded AI Processing via Dynamic and Static Loop Caching
- SPARC: Automated Root-Cause Analysis of Pre-Silicon Power Side-Channel Leakage in the Processor Design Flow