Accelerating EDA innovation through SoC design methodology convergence
According to Dr. Walden C. Rhines, chairman and CEO, Mentor Graphics Corp., verification has to improve and change every year just to keep up with the rapidly changing semiconductor technology. Fortunately, the innovations are running ahead of the technology and there are no fundamental reasons why we cannot adequately verify the most complex chips and systems of the future. He was speaking at the recently held DVCON 2014 in Bangalore, India.
A design engineer’s project time for doing design has reduced by 15 percent from 2007-2014, while the engineer’s time for doing verification had seen 17 percent increase during the same time. At this rate, in about 40 years, all of a designer’s time will be devoted to verification. At the current rate, there is almost no chance of getting a single-gate design correct on first pass!
To read the full article, click here
Related Semiconductor IP
- Band-Gap Voltage Reference with dual 2µA Current Source - X-FAB XT018
- 250nA-88μA Current Reference - X-FAB XT018-0.18μm BCD-on-SOI CMOS
- UCIe D2D Adapter & PHY Integrated IP
- Low Dropout (LDO) Regulator
- 16-Bit xSPI PSRAM PHY
Related Blogs
- 2024 Set The Stage For NoC Interconnect Innovations In SoC Design
- Consolidation and EDA innovation
- SoC verification through Managed service
- Arm Flexible Access one year later: Accelerating innovation for more than 60 partners and counting
Latest Blogs
- AI in Design Verification: Where It Works and Where It Doesn’t
- PCIe 7.0 fundamentals: Baseline ordering rules
- Ensuring reliability in Advanced IC design
- A Closer Look at proteanTecs Health and Performance Management Solutions Portfolio
- Enabling Memory Choice for Modern AI Systems: Tenstorrent and Rambus Deliver Flexible, Power-Efficient Solutions