Understanding Skew in 100GBASE-R4 applications
Tim Warland, AppliedMicro
EETimes (12/14/2011 3:35 PM EST)
The 100GBASE-R4 physical layer device converts 10-lanes running 10Gbps (CAUI) to 4-lanes running 25Gbps. The conversion process is data agnostic with no provision for rate adaptation, consequently skew management is an integral part of end-to-end system performance.
Recently ratified, the 100Gigabit Ethernet Standard, (IEEE802.3ba) defines a 100GBASE-LR4 and 100GBASE-ER4 interface for optical interfaces on single-mode fiber. The architecture includes the Physical Coding sub layer (PCS), connected on one side to the reconciliation sub-layer (RS) and MAC and to the PMA/PMD on the other side. Actually implementations are more likely to combine the PCS and PMA with the RS and MAC and interface to a second PMA and PMD (referred to as the PHY)
To read the full article, click here
Related Semiconductor IP
- nQrux® Root of Trust IP
- AXI to UCIe Bridge IP
- UCIe 2.x Controller IP
- SWI3S (SoundWire I3S Interface) Peripheral Controller Core IP
- OpenTitan-based RISC-V Secure Element
Related Articles
- Timing Optimization Technique Using Useful Skew in 5nm Technology Node
- Signal skew managed dynamically
- Put a Data Center in Your Phone!
- Radiation Tolerance is not just for Rocket Scientists: Mitigating Digital Logic Soft Errors in the Terrestrial Environment
Latest Articles
- A Secure dToF LiDAR SoC with Dual-Domain Fingerprinting and Event-Driven AFE Circuit Achieving Sensor-Level Attack Resilience
- ZTA-Q: an Open-source RISC-V Platform for Accurate Quantized CNN Inference
- Automated Pre-Silicon Verification of High-Speed DDR5 and LPDDR5/6 Memory Controllers: Closed-Loop Timing, Mode Register, and PHY Synchronization in UVM
- U-Sonic: An Open-Source 8-Channel Ultrasound Transmit IP in a 130 nm RISC-V SoC
- S-ALSA: Co-Design of Adiabatic Logic-based Sensing and Balanced Bit-Cells for Secure and Energy-Efficient MRAM