Processor architecture not a factor for low-power mobile systems
By Jonah Probell, YAP IP
DSP DesignLine (April 20, 2009)
Much is made in marketing literature of the energy efficiency of different processor architectures. The power consumption of the processor is relevant but a small component of the overall power budget of the device. The instruction set architecture (x86, ARM, or otherwise) has a minimal effect on the power consumption of a processor and is of negligible consequence to the mobile system power budget.
Mobile consumer electronics devices are generally built from some combination of the components shown in Table 1.
Ultimately these machines must serve their human users by tickling the senses. The human eye requires a certain amount of incident light energy to clearly see an image. That sets a minimum amount of light power per unit area that a display must emit. The 1.7 inch display of a clam shell flip phone requires about 150 mW, a 3.5 inch smart phone display requires about 600 mW, an 8.4-inch mobile internet device display requires about 3 watts, and a 15-inch notebook computer display might require 10 watts. Those numbers do vary significantly depending on how the user sets the brightness control.
DSP DesignLine (April 20, 2009)
Much is made in marketing literature of the energy efficiency of different processor architectures. The power consumption of the processor is relevant but a small component of the overall power budget of the device. The instruction set architecture (x86, ARM, or otherwise) has a minimal effect on the power consumption of a processor and is of negligible consequence to the mobile system power budget.
Mobile consumer electronics devices are generally built from some combination of the components shown in Table 1.
Ultimately these machines must serve their human users by tickling the senses. The human eye requires a certain amount of incident light energy to clearly see an image. That sets a minimum amount of light power per unit area that a display must emit. The 1.7 inch display of a clam shell flip phone requires about 150 mW, a 3.5 inch smart phone display requires about 600 mW, an 8.4-inch mobile internet device display requires about 3 watts, and a 15-inch notebook computer display might require 10 watts. Those numbers do vary significantly depending on how the user sets the brightness control.
To read the full article, click here
Related Semiconductor IP
- nQrux® Root of Trust IP
- AXI to UCIe Bridge IP
- UCIe 2.x Controller IP
- SWI3S (SoundWire I3S Interface) Peripheral Controller Core IP
- OpenTitan-based RISC-V Secure Element
Related Articles
- An Embedded Processor Architecture With Extensive Support For SoC Debug
- Associative Processing Array Solves Mobile App Processor Challenges
- A Low-Power 16-channel AD Converter and Digital Processor ASIC
- Processor Architecture for High Performance Video Decode
Latest Articles
- A Secure dToF LiDAR SoC with Dual-Domain Fingerprinting and Event-Driven AFE Circuit Achieving Sensor-Level Attack Resilience
- ZTA-Q: an Open-source RISC-V Platform for Accurate Quantized CNN Inference
- Automated Pre-Silicon Verification of High-Speed DDR5 and LPDDR5/6 Memory Controllers: Closed-Loop Timing, Mode Register, and PHY Synchronization in UVM
- U-Sonic: An Open-Source 8-Channel Ultrasound Transmit IP in a 130 nm RISC-V SoC
- S-ALSA: Co-Design of Adiabatic Logic-based Sensing and Balanced Bit-Cells for Secure and Energy-Efficient MRAM