Moore's Law did indeed stop at 28nm
September 21, 2016
As we have predicted two and a half years back, the industry is bifurcating, and just a few products pursue scaling to 7nm while the majority of designs stay on 28nm or older nodes.
Our march 2014 blog Moore’s Law has stopped at 28nm! has recently been re-confirmed. At the time we wrote: “From this point on we will still be able to double the amount of transistors in a single device but not at lower cost. And, for most applications, the cost will actually go up.” This reconfirmation can be found in the following IBS cost analysis table slide, presented at the early Sept FD-SOI event in Shanghai.
To read the full article, click here
Related Semiconductor IP
- Chiplet Die-to-Die Interconnect IP Solution
- High speed MACsec Engine 100G/200G/400G/800G/1.6T
- Temperature/Voltage sensors
- AMBA Bus Host to eSPI Controller/Target
- AMBA Bus Host to eSPI Controller
Related Blogs
- Moore's Law and 28nm Yield
- Moore's Law Has Stopped at 28nm!
- 28nm Was Last Node of Moore's Law
- Moore’s Law and 40nm Yield
Latest Blogs
- Cadence Achieves Successful Silicon Validation of 1st IP Test Chips on Intel 18A
- From Classical CAN and CAN FD to CAN XL: Functional Safety and Security for Next-Generation In-Vehicle Communication
- Accelerating Embedded Memory Performance with 16-bit xSPI PSRAM IP
- Why nonce reuse can break AES-GCM security in embedded systems
- PQSecure™-Agility Earns NIST CAVP Validation