What Does it Take to Migrate from e to UVMe?
September 6, 2012
So you are developing your verification environment in e, and like everyone else, you've been hearing a lot of buzz surrounding UVM (Universal Verification Methodology). Maybe you would also like to give it a try. The first question that pops in your mind is, "What would it take to migrate from e to UVM e?"
Well, this is a bit of a trick question. The short answer is that if you've adopted eRM in the past, migration to UVM e will only take a few minutes. If your environment is not eRM-compliant, it will take you longer.
And now to the details. What exactly is UVM e, in comparison to native e (IEEE 1647), and to eRM? What is in UVM? And what's all the fuss about?
To read the full article, click here
Related Semiconductor IP
- Chiplet Die-to-Die Interconnect IP Solution
- High speed MACsec Engine 100G/200G/400G/800G/1.6T
- Temperature/Voltage sensors
- AMBA Bus Host to eSPI Controller/Target
- AMBA Bus Host to eSPI Controller
Related Blogs
- JESD204 Frame Mapping explained from converter samples to lanes
- From vision to reality in RISC-V: Interview with Karel Masarik
- Virtual Platforms from Arm and Partners Available Now to Accelerate and Transform Automotive Development
- Rambus CXL IP: A Journey from Spec to Compliance
Latest Blogs
- Embedded Security explained: Advanced Encryption Standard (AES)
- Cadence Demonstrates PCIe 8.0 PHY at PCI-SIG DevCon 2026
- Cadence Achieves Successful Silicon Validation of 1st IP Test Chips on Intel 18A
- From Classical CAN and CAN FD to CAN XL: Functional Safety and Security for Next-Generation In-Vehicle Communication
- Accelerating Embedded Memory Performance with 16-bit xSPI PSRAM IP