FPGA Prototyping: From Homebrew to Integrated Solutions
Years ago, when FPGA prototyping started, there were no solutions that you could go out and buy and everything was created as a one-off: buy some FPGAs or an FPGA-based board, and put it all together. It was a lot of effort, nobody really knew in advance how long it would take, there was very limited visibility for debug and the whole thing was basically unsupportable. There is more discipline these days but even so, roughly half of all FPGA prototyping is done in a proprietary way that doesn't scale as designs get larger and lacks more and more desirable features. The other half of the market uses an integrated solution that ties together FPGA-based hardware, the software for getting the design up and running, debug and daughter boards for hardware interfaces.
Last week I talked to Johannes Stahl of Synopsys about the new solution that they are announcing today.
To read the full article, click here
Related Semiconductor IP
- TSMC 7nm 0V75 / 0V9 ESD Local Clamp – Low Cap
- TSMC 65nm 3V3 ESD Local Clamp – Rad Hard
- TSMC 5nm 1V8, 1.2V and 0.9V ESD Local Protection – Low Cap
- TSMC 3nm 3V3 ESD Local Clamp
- TSMC 3nm 1V2 ESD Local Clamp – Low Capacitance
Related Blogs
- Do we need a new FPGA structure for prototyping?
- Virtual Platforms plus FPGA Prototyping, the Perfect Mix
- FPGA Prototyping of System-on-Chip (SoC) Designs
- Five Challenges to FPGA-Based Prototyping
Latest Blogs
- Beyond Trusted: What the NSA’s New Guidance Means for Hardware Security
- A scalable, shader-programmable vector graphics GPU core for low-power MCUs
- Navigating ISO 26262 Part 11: A Guide for Semiconductor Architects
- Embedded Security explained: Digital signatures
- Hardware security verification must go beyond functional testing