Reap the benefits of a general-purpose interface USB 3.0 device controller
Sethu Jose, Subha Komath, Cypress Semiconductor
EETimes (1/17/2013 12:47 PM EST)
Since its introduction in 2000, USB 2.0 has been the de-facto interface standard of the PC world. With a transfer rate of 480Mbps, it is lightning fast and served as an apt solution for many interfacing needs. However, with the rise in demand for higher data rate applications like HD video streaming and high capacity hard disks, the reign of USB 2.0 is slowly being replaced by its successor – USB 3.0.
In communication world, faster is always better. With USB 3.0, 10 times faster data transfers are within reach. With a signaling rate of 5Gbps, SuperSpeed has dawned as a ‘Fast Sync and Go’ Technology. Thanks to SuperSpeed, users can copy a HD movie of 25 GB in just 70 seconds compared to 13.9 minutes at High Speed. This means no more waiting for consumers.
To read the full article, click here
Related Semiconductor IP
- USB 3.0 Gen1 / Gen2 Device Controller IP
- SuperSpeed USB 3.0 Device Controller Supporting SSIC and HSIC
- USB 3.0 Device Upgrade IP Core
- USB 3.0 Device
- USB 3.0 High/Full/Low-Speed Host + Device Controller IP
Related Articles
- Verification of USB 3.0 Device IP Core in Multi-Layer SystemC Verification Environment
- IP Integration - Size Matters! - Reducing the size of a USB 2.0 device core
- Transaction Level Model of the USB On-The-Go controller IP core
- Optimization of current-limiting solutions for USB 3.0
Latest Articles
- A Low-Latency ASIC Architecture for Real-Time Line Segment Detection
- BitFair: A 12nm Bit-Serial CNN Accelerator with Learnable Early Termination and Adaptive Bit Ordering for Ultra-Low-Power XR Vision
- A Flexible Sparsity-Aware FPGA Accelerator with Column-Wise Compression for Efficient CNN Inference
- Reducing Instruction-Fetch Energy in RISC-V for Embedded AI Processing via Dynamic and Static Loop Caching
- SPARC: Automated Root-Cause Analysis of Pre-Silicon Power Side-Channel Leakage in the Processor Design Flow