Is Your JEDEC UFS Verification Future-Proofed with UME Support?
October 20, 2014
There is not much debate left on the adoption of the JEDEC UFS technology. It has gained enough momentum and has proved a winner. No doubt, JEDEC UFS is a design and verification challenge. You might end up focusing all your attention on the JEDEC UFS, MIPI UniPro and MIPI M-PHY design and verification. Thus there are chances that an optional but important specification - Unified Memory Extension 1.0 specification (UME 1.0), might slip your radar. This specification is captured in the JEDEC specification JESD220-1.pdf.
Related Semiconductor IP
- 1.6T Ultra Ethernet Controller
- Chiplet Die-to-Die Interconnect IP Solution
- High speed MACsec Engine 100G/200G/400G/800G/1.6T
- Temperature/Voltage sensors
- AMBA Bus Host to eSPI Controller/Target
Related Blogs
- Universal Browser Support for JPEG XL: Is Your Hardware Ready for the New Standard?
- How did JEDEC UFS beat the MIPI CSI3 and DSI2 in adoption race?
- JEDEC UFS Verification - Top 3 Challenges
- JEDEC UFS Verification: Secret Of Our Success
Latest Blogs
- Embedded Security explained: Advanced Encryption Standard (AES)
- Cadence Demonstrates PCIe 8.0 PHY at PCI-SIG DevCon 2026
- Cadence Achieves Successful Silicon Validation of 1st IP Test Chips on Intel 18A
- From Classical CAN and CAN FD to CAN XL: Functional Safety and Security for Next-Generation In-Vehicle Communication
- Accelerating Embedded Memory Performance with 16-bit xSPI PSRAM IP