DDR-PHY Interoperability Using DFI
September 7, 2016
The DDR PHY Interface (DFI) is used in several consumer electronics devices including smart phones. DFI is an interface protocol that defines signals, timing, and programmable parameters required to transfer control information and data to and from the DRAM devices, and between MC (Micro Controller) and PHY. DFI is applicable to all DRAM protocols including DDR4, DDR3, DDR2, DDR, LPDDR4, LPDDR3, LPDDR2 and LPDDR.
To read the full article, click here
Related Semiconductor IP
- USB-C Power Delivery IP Core
- Configurable Multi-Channel DMA Controller
- Samsung Foundry 4nm 1V8 GPIO I3C
- Root-of-Trust IP - High-Assurance Security for Advanced and Regulated Applications
- Root-of-Trust IP - Enhanced-Assurance, Configurable Security for Scalable Semiconductor Designs
Related Blogs
- Tips on Using e Macros to Raise Abstraction and Facilitate Reuse
- An inconvenient truth about using DDR3 SDRAM for embedded designs
- What's it take to design DDR4 into your next SoC? Newly released DFI 3.0 Spec opens the flood gates for DDR4 design
- Some critical considerations for SoC and Silicon Realization teams thinking about using ARM Cortex-A7 or ARM Cortex-A8 processor cores
Latest Blogs
- The $725 Million Chip Development: Why Execution Risk, Not IP Cost, Now Dictates Advanced-Node Survival
- From photon to actuation: How physical AI is redefining embedded compute
- Secure Boot for embedded Linux on Efinix Ti375C529: Getting started with KiviBoot-Linux
- Akida in High-Frequency Trading: The Smart Signal Layer
- Cadence Expands Sovereign AI in Europe: From Chips to AI Factories