Bit Error Rates for USB 3.2
Bit Error Rates and Snoopy’s rejection letters
Bit Error Rates (BER) in wired and wireless communication communicate the “allowable” or target number of errors (rejected or non-transmitted data) that can occur over some given time. Usually this is measured of a period time like a second.
Wired interfaces enable faster speeds because a hard wire has less ways it can be interfered with on the path from one product to another. Even wired interfaces like USB and Ethernet, basically any wired interface port, generates https://en.wikipedia.org/wiki/Electromagnetic_interference which can interfere with data transmission inside or outside the device. For example, Electromagnetic Interference (EMI) in PCs is tightly regulated by the FCC in the U.S. For USB specifically, the BER tolerance is low because it’s a wired interface.
The FCC does not regulate hair dryers and thus can emit enough EMI to bring down a nuclear power plant.
To read the full article, click here
Related Semiconductor IP
- USB 3.2 - Validates high-speed USB designs for protocol compliance and performance
- USB 3.2 and DP 1.4 TX Combo PHY
- USB 3.2 Gen2x2 with PIPE 4.3 and USB2.0 with UTMI+ interface
- USB 3.2 Gen2 PHY IP, Silicon Proven in TSMC 28HPC+
- USB 3.2 Gen2 PHY IP, Silicon Proven in TSMC 16FFC
Related Blogs
- USB 3.2 - The USB Type-C Connector Finally Met its Match
- USB 3.2 Primer - Part 1
- USB 3.2 Cable Lengths and Water Delivery
- Programmable Hardware Delivers 10,000X Improvement in Verification Speed over Software for Forward Error Correction
Latest Blogs
- M31 High-Speed and Long-Channel MIPI C/D-PHY Solution on TSMC N3P/N3C
- Understanding security certification and how analog IP can help
- Embedded Security explained: Secure boot for embedded systems
- World's First Standards-Compliant 112G PHY IP for Linear Optics: A Turning Point for AI Interconnects
- One Key for Every Door: How Aliro Extends the UWB Digital Key Beyond the Car