DDR2 Controller IIP

DDR2 interface provides full support for the DDR2 interface, compatible with JESD79-2F specification and DFI-version 2.0 or higher Specification Compliant. Through its DDR2 compatibility, it provides a simple interface to a wide range of low-cost devices. DDR2 IIP is proven in FPGA environment. The host interface of the DDR2 can be simple interface or can be AMBA AHB, AMBA AHB-Lite, AMBA APB, AMBA AXI, AMBA AXI-Lite, Tilelink, OCP, VCI, Avalon, PLB, Wishbone or Custom protocol.

DDR2 Controller IIP is supported natively in Verilog and VHDL

• Supports DDR2 protocol standard JESD79-2F Specification.
• Compliant with DFI-version 2.0 or higher Specification.
• Supports all the DDR2 commands as per the specs.
• Supports up to 16 AXI ports with data width upto 512 bits.
• Supports controllable outstanding transactions for AXI write and read channels
• Supports in port arbitration and multi port arbitration.
• Supports user programmable page policy.
• Closed page policy
• Open page policy
• Supports Error Checking and correction (ECC).
• Supports retry on ECC error, with retry limit user controllable.
• Supports high clock speeds in ASIC and FPGA.
• Supports low latency for write and read path.
• Supports reordering of transactions for higher performance.
• Supports double data rate interface.
• Supports the following densities.
• 128MB
• 256MB
• 512MB
• 1GB
• 2GB
• 4GB
• Supports 8 internal banks.
• Supports the following devices.
• X4
• X8
• X16
• Supports all speed grades as per specification.
• Quickly validates the implementation of the DDR2 standard JESD79-2F.
• Supports Programmable Write latency and Read latency.
• Supports Programmable burst lengths: 4,8.
• Supports the following burst types.
• Sequential
• Interleave
• Supports for burst sequence.
• Supports for All Mode registers programming.
• Supports for Extended Mode registers programming.
• Supports for Write data Mask.
• Supports for Power Down features.
• Supports for Self Refresh mode.
• Supports Auto precharge option for each burst access.
• Supports for input clock stop and frequency change.
• Supports for ODT(On-Die Termination).
• Supports for DLL.
• Fully synthesizable
• Static synchronous design.
• Positive edge clocking and no internal tri-states.
• Scan test ready
• Simple interface allows easy connection to microprocessor/microcontroller devices

• Single site license option is provided to companies designing in a single site.
• Multi sites license option is provided to companies designing in multiple sites.
• Single Design license allows implementation of the IP Core in a single FPGA bitstream and ASIC.
• Unlimited Designs, license allows implementation of the IP Core in unlimited number of FPGA bitstreams and ASIC designs.

• The DDR2 interface is available in Source and netlist products.
• The Source product is delivered in verilog. If needed VHDL, SystemC code can also be provided.
• Easy to use Verilog Test Environment with Verilog Testcases.
• Lint, CDC, Synthesis, Simulation Scripts with waiver files.
• IP-XACT RDL generated address map.
• Firmware code and Linux driver package.
• Documentation contains User's Guide and Release notes.