How Will 5G Advanced Change RF Design?
By Gina Roos, EETimes (June 26, 2023)
“There will be some new challenges in RF front-end [RFFE] component design for infrastructure due to increased instantaneous bandwidths and higher-frequency bands in FR3 that may be used to meet the ever-increasing bandwidth needs,” said Jeff Gengler, director of RF applications engineering at Qorvo Inc.
“On the component design side, increased integration within modules will significantly help address optimization and consistency of performance over more challenging specifications,” Gengler added. “Increased integration allows for more of the combined system to be tested and validated by the component provider. Integration decreases the size of the solution, which helps reduce cost and helps meet requirements for tighter array pitch at higher frequencies.”
To read the full article, click here
Related Semiconductor IP
- TSMC 7nm 0V75 / 0V9 ESD Local Clamp – Low Cap
- TSMC 65nm 3V3 ESD Local Clamp – Rad Hard
- TSMC 5nm 1V8, 1.2V and 0.9V ESD Local Protection – Low Cap
- TSMC 3nm 3V3 ESD Local Clamp
- TSMC 3nm 1V2 ESD Local Clamp – Low Capacitance
Related News
- How Will Deep Learning Change SoCs?
- How Apple will dodge an Imagination lawsuit
- SDR RF IP, 100MHz-2.6GHz, for ultra-low power applications from IoT, M2M to 5G available from T2MIP
- Driven by Accelerating Demand for Leading 5G RF Solutions, GLOBALFOUNDRIES and Soitec Announce RF-SOI Wafer Supply Agreement
Latest News
- First Benchmarks Revealed for Jalapeño, OpenAI’s Clean-Sheet General Purpose AI Accelerator ASIC
- MIPS Leads Open Standards Development for Physical AI Platforms as RISC-V International Premier Member
- SEALSQ’s Subsidiary IC'Alps Advances QASIC Roadmap for Sovereign, Quantum-Resistant Application-Specific Integrated Circuits
- NVMe 2.4 Update Adds Post-Quantum Security, Power Controls
- Agentrys Raises $24.5 Million to Build Agentic Design Automation for Chipmakers