Philips to use Tality for 8051 shrinks
Philips to use Tality for 8051 shrinks
By Chris Edwards, EE Times UK
October 12, 2001 (6:11 a.m. EST)
URL: http://www.eetimes.com/story/OEG20011011S0013
Tality has signed a deal with Philips Semiconductor that will see the design house port a range of 8bit microcontrollers to 0.35µm processes as part of a cost-reduction move by Philips. Philips will continue to work on new devices based on the 8051 architecture, as well as its 16bit derivative, the XA. Tality will take the existing product line and perform the shrinks needed to get them onto 0.35µm. David Haeussler, the Philips client partner at Tality, said: "Most of the products are on processes older than 0.5µm. We will take them down to 0.35µm to keep them 5V compatible."
Related Semiconductor IP
- TSMC 7nm 0V75 / 0V9 ESD Local Clamp – Low Cap
- TSMC 65nm 3V3 ESD Local Clamp – Rad Hard
- TSMC 5nm 1V8, 1.2V and 0.9V ESD Local Protection – Low Cap
- TSMC 3nm 3V3 ESD Local Clamp
- TSMC 3nm 1V2 ESD Local Clamp – Low Capacitance
Related News
- Philips Semi, Cadence's Tality unit team up in Bluetooth solutions
- Philips Semiconductors (Eindhoven, Netherlands) and Tality Corp. (San Jose, Calif.) prep Bluetooth reference modules
- Philips develops one-chip stereo radio for embedded use in consumer products
- Tality Restructures Its Wireline Communications Segment
Latest News
- First Benchmarks Revealed for Jalapeño, OpenAI’s Clean-Sheet General Purpose AI Accelerator ASIC
- MIPS Leads Open Standards Development for Physical AI Platforms as RISC-V International Premier Member
- SEALSQ’s Subsidiary IC'Alps Advances QASIC Roadmap for Sovereign, Quantum-Resistant Application-Specific Integrated Circuits
- NVMe 2.4 Update Adds Post-Quantum Security, Power Controls
- Agentrys Raises $24.5 Million to Build Agentic Design Automation for Chipmakers