MIPI RX PHY is a mass production IP for D-PHY v1.2 and C-PHY v1.2 protocols.
- MIPI PHY
- Mass Production
MIPI RX PHY is a mass production IP for D-PHY v1.2 and C-PHY v1.2 protocols.
MIPI RX controller on SMIC 28nm
MIPI RX controller is a mass production IP in SMIC 28nm supported MIPI DSI & DCS protocols.
DSC decoder IP is compliant with standard VESA Display Stream Compression version 1.1/1.2/1.2a.
The UniIC GDDR6 PHY,subsequently referred to as the UNIIC_GD6PHY, is designed for performance and power efficiency, its target is…
DDR4 IO for memory PHY, 3200Mbps on SMIC 40nm
The DDR4 IO is used to transfer the Command/Address/Clk and Data between the memory controller PHY and the DRAM device.
Low power XTAL oscillator, 4M~40MHz on SMIC 40nm
The present IP is a crystal oscillator.
Temperature Sensor with PTAT voltage output on XMX 55nm
The present IP is Temperature sensor (TS) circuit.
Temperature Sensor with 10Bit Digital output on SMIC 40nm
The present IP is a high accuracy and integrated temperature sensor.
10Bit 25MHz sigma-delta ADC for VT sensor on SMIC 40nm
The present IP is a single-ended 10-bit Sigma-Delta (SD) analog-to-digital converter.
8MHz RC oscillator on UMC 55nm
he present IP is a low dissipation and high precision relaxation oscillator.
100MHz RC oscillator on SMIC 65nm
The present IP is developed with SMIC 65nm process.
20MHz RC oscillator on SMIC 65nm
The present IP is a RC oscillator that developed with SMIC 65nm process.
Low-Speed 40KHz RC oscillator on SMIC 40nm
The present IP is a low speed and low powerinternal RC oscillator circuit.
High Speed 132MHz RC oscillator on SMIC 40nm
The present IP is a high speed Low Power RC oscillator that developed with SMIC 40nm process.
Low-Speed 40KHz RC oscillator on UMC 55nm
The present IP is a low power and low speed internal RC oscillator circuit (LSI RC OSC), used to drive the independent watchdog (…
Low-Offset Programmable Gain Amplifier on UMC 55nm
This present IP is applied to amplify the input signal with the programmable gain in Standalone/PGA mode or to work as a buffer i…
LDO regulator on SMIC 40nm, 0.6~1.1v output
The present IP is a low dropout voltage regulator, which can support 10uA current load.
LDO regulator on SMIC 40nm, 2.1v output
The present IP is a low dropout voltage regulator, which can support 360uA current load.
The present IP is a voltage reference buffer, which is developed with SMIC 65nm ETOX Nor Flash process.
LDO regulator on SMIC 40nm, 1.13v output
The present IP is a low dropout voltage regulator, which can support 10uA DC current load.