MIPI RFFE Slave IIP

MIPI RFFE Slave interface provides full support for the two-wire MIPI RFFE synchronous serial interface, compatible with RFFE specification. Through its RFFE compatibility, it provides a simple interface to a wide range of low-cost devices. MIPI RFFE Slave IIP is proven in FPGA environment.The host interface of the MIPI RFFE can be simple interface or can be AMBA APB, AMBA AHB, AMBA AHB-Lite, AMBA AXI, AMBA AXI-Lite, VCI, OCP, Avalon, PLB, Tilelink, Wishbone or Custom protocol.

MIPI RFFE Slave IIP is supported natively in Verilog and VHDL

• Compliant with version 3.0 MIPI RFFE Specifications.
• Full MIPI RFFE Slave functionality.
• Supports following frames
• Command Frame
• Data/Address Frame
• No Response Frame
• Supports extended register read/writes
• Supports interrupt summary and identification command sequence
• Support Trigger and Extended trigger modes
• Support Masked write command sequence
• Supports Timed Trigger
• Supports Mappable Triggers
• Support Synchronous read
• Support Normal and Secondary operation mode
• Support USID Programming Procedure 1,2 and 3
• Support Group slave ID
• Supports device enumeration
• Supports Half-Speed Data Response (HSDR) Accesses
• Supports Full Command Sequence at Half-Speed SCLK
• Supports Delayed Read-back
• Supports Reserved Register Allocations in Basic Address Space (0x1C – 0x1F)
• Supports Reserved Register Allocations in Extended Address Space (0x20 – 0x3F)
• Supports Write Slave State via PWR_MODE bits
• Supports Read Slave State via PWR_MODE bits
• Supports Read PRODUCT_ID, MANUFACTURER_ID and USID from reserved registers.
• Support Interrupt capable slave
• Supports Extended Frequency Range up to 52 MHz
• Supports Error detection
• Undefined command frame
• Command frame with parity error
• Command frame length error
• Address frame with parity error
• Data frame with parity error
• Read of unused register
• Write of an unused register
• Read using the broadcast ID or a GSID
• Fully synthesizable
• Static synchronous design
• Positive edge clocking and no internal tri-states
• Scan test ready
• Simple interface allows easy connection to microprocessor/microcontroller devices
• Optionally this core can be built to have SPI or I2C interface for application where slave can have multiple interfaces like RFFE or SPI or I2C Interface
• This core achieves ASIL B and can be made to achieve ASIL D as per ISO26262

• Single Site license option is provided to companies designing in a single site.
• Multi Sites license option is provided to companies designing in multiple sites.
• Single Design license allows implementation of the IP Core in a single FPGA bitstream and ASIC.
• Unlimited Designs, license allows implementation of the IIP Core in unlimited number of FPGA bitstreams and ASIC designs.

• The MIPI RFFE Slave interface is available in Source and netlist products.
• The Source product is delivered in verilog.If needed, VHDL and SystemC can also be provided
• Easy to use Verilog Test Environment with Verilog Testcases
• Lint, CDC, Synthesis, Simulation Scripts with waiver files
• IP-XACT RDL generated address map
• Firmware code and linux driver package
• Documentation contains User's Guide and Release notes.
• ISO26262 Safety Manual (SAM) Document
• ISO26262 Failure Modes, Effects and Diagnostics Analysis (FMEDA)Document