Vendor: VeriSyno Microelectronics Co., Ltd. Category: Single-Protocol PHY

DDR3/2 PHY

The DDR3/2 PHY is a mixed-signal IP solution designed to provide DDR 3/2 SDRAM connectivity in a System-On-a-Chip (SOC) design ta…

Contact Provider Request Datasheet

Overview

The DDR3/2 PHY is a complete mixed-signal IP solution designed to provide DDR 3/2 SDRAM connectivity in a System-On-a-Chip (SOC) design targeted to a specific fabrication process. The DDR3/2 PHY supports a range of DDR3 SDRAM speeds, from DDR3-667 through DDR3-1600, with backward compatibility provided for DDR2-667 through DDR2-1066 devices. Targeted toward supporting x8 and x16 DDR3 SDRAM components, DDR3/2 PHY supports interfaces of varying widths, from a minimum of 8 bits wide, in 8-bit increments. Delivered to customers as hardened IP components— Address/Command, DATX8, and SSTL I/O Library—implementations of the DDR3/2 PHY are compatible with JEDEC DDR2 and DDR3 SDRAMs, helping ensure customer success.

Key features

  • ? DDR2/DDR3/DDR3U/DDR3L/LVCMOS operating modes
  • ? Compatible with JEDEC standard DDR2/DDR3/DDR3U/DDR3L SDRAMs
  • ? Scalable performance from DDR2-667 through DDR3-1600
  • ? Maximum controller clock frequency of 400MHz resulting in maximum SDRAM data rate of 1600 Mbps
  • ? Data path width scales in 8-bit increments
  • ? Delivery of product as hardened IP components allows precise control of timing critical delay and skew paths
  • ? Includes embedded PLL and DDLs necessary to meet timing specifications
  • ? Multiple memory-rank support, up to four ranks
  • ? DDR3 PHY-Controller interface runs at 1/4 the memory baud rate, simplifying core logic timing constraints
  • ? Write leveling delay line (WLDL) to compensate address and control versus data delays of up to 1 clock cycle or 2500ps
  • ? Write and read bit delay lines (BDLs) compensate per-bit delay skew of up to 600ps at fast PVT; delay resolution approximately 15ps under typical conditions
  • ? Locally calibrated master and slave delay lines minimize OCV and ACLV effects, and accommodate V, T timing drift; delay resolution approximately 15ps under typical conditions
  • ? At-speed loopback testing on both the address and data channels
  • ? Delay line oscillator test mode
  • ? MUX-scan ATPG

What’s Included?

  • We offer high-speed interface IPs designed for 28~90nm fabrication processes in various foundries. We can also customize porting IPs for customers requiring 90~180nm fabrications and support more advanced processes as needed.

Specifications

Identity

Part Number
DDR3/2 PHY
Vendor
VeriSyno Microelectronics Co., Ltd.
Type
Silicon IP

Provider

VeriSyno Microelectronics Co., Ltd.
HQ: The People's Republic of China
VeriSyno Microelectronics Co., Ltd. is a national high-tech enterprise dedicated to the research and development of semiconductor IPs. The company’s main products include mixed-signal high-speed interface IPs such as USB, HDMI, DDR, MIPI, PCIe, SATA, and various analog IPs such as ADC, DAC, PLL, LVDS, as well as independently developed PSRAM interface IO solutions and vMAC series IPs. As one of the important semiconductor IP suppliers in China, in active collaboration with local foundries, VeriSyno has long been committed to the porting of those mature interface IPs to processes such as 22/28/40/55nm, to ensure secure and reliable supply of domestic IPs. The company’s diversified IP products have been widely used in industries such as industrial, medical, AI, and IoT. VeriSyno was established in September 2018 and is headquartered in Hefei, Anhui, with branch offices in Beijing, Shanghai, and Shenzhen.
Contact VeriSyno Microelectronics Co., Ltd.

Learn more about Single-Protocol PHY IP core

UFS Goes Mainstream

UniversalFlash Storage (UFS) was created for mobile applications and computer systems requiring high performance and low power consumption. These systems typically use embedded Flash based on the JEDEC standard eMMC. UFS was defined by JEDEC as the evolutionary replacement for eMMC offering significantly higher memory bandwidth. The standard builds on existing standards such as the SCSI command set, the MIPI Alliance M-PHY and UniPro as well as eMMC form factors to simplify adoption and development.

Design IP Faster: Introducing the C~ High-Level Language

In this paper, we introduce a new high-level, dataflow programming language called C~ (“C flow”) that further increases productivity by raising the level of abstraction from behavioral descriptions, while overcoming the limitations of C for hardware design. We present the syntax and semantics of this language, and the framework that provides hardware and software code generation. This paper illustrates the benefits of using C~ for hardware design of a IEEE 802.3 MAC, synthesized for FPGA and for 90nm CMOS technology.

Universal Flash Storage: Mobilize Your Data

Universal Flash Storage (UFS) was created for mobile applications and computer systems requiring high performance and low power consumption. These systems typically use embedded Flash based on the JEDEC standard eMMC. UFS was defined by JEDEC as the evolutionary replacement for eMMC offering significantly higher memory bandwidth. The standard builds on existing standards such as the SCSI command set, the MIPI Alliance M-PHY and UniProSM as well as eMMC form factors to simplify adoption and development.

Can MIPI and MDDI Co-Exist?

Since MIPI and MDDI standards both target interfaces to cameras and displays on mobile devices, are two separate standards really needed?

Frequently asked questions about Single-Protocol PHY IP

What is DDR3/2 PHY?

DDR3/2 PHY is a Single-Protocol PHY IP core from VeriSyno Microelectronics Co., Ltd. listed on Semi IP Hub.

How should engineers evaluate this Single-Protocol PHY?

Engineers should review the overview, key features, supported foundries and nodes, maturity, deliverables, and provider information before shortlisting this Single-Protocol PHY IP.

Can this semiconductor IP be compared with similar products?

Yes. Buyers can compare this product with similar semiconductor IP cores or IP families based on category, provider, process options, and structured technical specifications.

×
Semiconductor IP